Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Microphone For a cabled microphone, plug it into one of the 1/4” phone jacks before turning on the power. Turn the power ON (the red LED will light) and adjust the volume to the desired level while speaking into the microphone. Receiver If using a wireless microphone transmitter, first turn on the receiver power and adjust the volume to 10 o’clock. Then turn the speaker power and adjust the volume level to 10 o’clock. Line-In Two pair of RCA jacks are provided to connect audio from CD, LCD Projector or other audio sources. The Left and Right channels are “summed” because the speaker system is monaural. Tone Control The tone control would normally be set at 12 o’clock and will have little effect when using a microphone. When playing music turning the control clockwise will increase the treble, while turning counter clockwise will increase the bass. LED Indicators There are two LED indicators behind the speaker grille. Red indicates that there is a UHF transmission signal from the microphone. The green lights when audio is being transmitted. For 16-Channel UHF Powered Speaker Only Transmitters There are two wireless microphone transmitters available; Q-316 handheld microphone and M-316 Beltpack transmitter. Q-316 Install 2 AA Alkaline batteries (included) and switch ON the Microphone. Wait 5 seconds prior to talking into the microphone. Adjust the UHF receiver volume and speaker volume to the desired level. M-316 Install 2 AA Alkaline batteries (included). Plug in one of the three available microphones. (see page 5). The M-316 has a volume control which should be set at the lowest level before turning on the power. After turning the power ON gradually increase the volume to a comfortable level. As with the handheld microphone there is a 3-5 second delay before transmitting. Microphone Lockout Two wireless microphones cannot be used at the same time unless one is turned off while the other is being used. Otherwise the first to be turned on will block out the other. NOTES Turn the transmitter power switch off when not being used to minimize battery drain. 5 Specifications Speaker System (PI30, PI30-PS and PI30-SP) Power Capacity 30 Watts RMS power capacity, 6 Ohms impedance Sound Pressure Level: 93 dB, 1 Watt @ 1 Meter Dispersion: -3dB @ 120 degrees off axis Frequency Response: 250Hz to 12KHz Transducers: Three each 3.5” Diameter, High Energy Neodymium Magnets, 10 Watts RMS capacity 3/4” Dia. Voice Coil, 16 Ohm Amplifier: 15 Watts RMS @ 5% THD Power Source: 100-240 volt AC universal power supply 12 VDC to amplifier Dimensions: 12” H x 5” W x 4” D Weight: Speaker 3 lbs. Bracket 1.3 lbs. Compliance: Power Adapter CE, C-UL PI30 Only Wireless System Receiver: One 16 channel selectable UHF diversity wireless receivers 798-805 MHz. Antennas are hidden internally. Microphone Transmitters: Handheld wireless microphone or beltpack transmitters optional. Powered by 2 ea. 1.5 volt AA batteries (included). Choice of headset, collar or lapel microphone for the be...
Эта инструкция также подходит к моделям:Акустика - PI30 (438.66 kb)
Акустика - PI30-PS (438.66 kb)
Акустика - PI30-SP (438.66 kb)
Акустика - PI30-PS (438.66 kb)