Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
If you use an amplifier with adjustable crossover frequency, it is recommended to select 180 Hz (or close to this figure) as the crossover frequency for your front, center, and surround speakers. Adjusting the subwoofer (..) Front Panel POWER Turns on the speaker system. ON/STANDBY indicator Lights up green when the subwoofer is on. Lights up red when the subwoofer is in power saving mode. Rear Panel LEVEL Rotate to adjust the volume. To enjoy high-quality sound, do not turn the subwoofer volume too high. BASS BOOST Rotate to adjust the level of BASS BOOST. PHASE Slide to select NORMAL or REVERSE phase polarity. Switching the phase polarity may provide better bass reproduction in certain listening environments (depending on the type of front speakers, the position of the subwoofer and the adjustment of the BASS BOOST). Select the setting that provides the sound you prefer when listening in your normal listening position. POWER SAVE Activate the auto power on/off function. If the subwoofer is on and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. If a signal is input to the subwoofer, the subwoofer automatically turns on. Troubleshooting Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer. There is no sound from the speaker system. • Make sure all the connections have been correctly made. • Make sure the volume on the amplifier has been turned up properly. • Make sure the program source selector on the amplifier is set to the proper source. • Check if headphones are connected. If they are, disconnect them. • Make sure that the subwoofer isn’t in power saving mode. If you turn down the volume level too low, the auto power on/off function may activate, causing the subwoofer to enter power saving mode. There is distortion in the subwoofer sound output. • Check if any sound-enhancing functions have been activated on the amplifier. If they have, turn them off. • If the sound distorts when you turn on the bass reinforcement from your amplifier (such as DBFB, GROOVE, the graphic equalizer, etc.), turn down the bass reinforcement and adjust the level. There is hum or noise in the speaker output. • Make sure all the connections have been correctly made. • Make sure none of the audio components are positioned too close to the TV set. • If the volume level of the subwoofer is turned up to maximum, extraneous noise may be output. The sound has suddenly stopped. • Make sure all the connections have been correctly made. Contact between bare speaker wires at the speaker terminals may cause a short circuit. Bass sounds are produced too heavily. • Some material is recorded with strong emphasis on bass sounds, which may be excessive in some cases. If this happens, rotate BASS BOOST towards minimum. Howling occurs. • Reposition the speakers or turn down the volume on the amplifier. Specifications SS-FVS350 (front speakers for SA-VS350H) Speaker system 2 way Speaker units Woofer: 60 . 100 mm, cone type Tweeter: 25 mm, balanced dome type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 150 W Sensitivity level 81 dB (1 W, 1 m) Frequency range 120 Hz - 50,000 Hz Dimensions (w/h/d) Approx. 82 . 1,060 . 100 mm, including front grille, (Diameter of base: 250 mm) Mass Approx. 5.0 kg SS-CNV350 (center speaker) Speaker system 2 way Speaker units Woofer: 57 mm (. 2), cone type Tweeter: 25 mm, balanced dome type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 150 W Sensitivity level 81 dB (1 W, 1 m) Frequency range 120 Hz - 50,000 Hz Dimensions (w/h/d) Approx. 345 . 86 . 98 mm, including front grille Mass Approx. 1.7 kg SS-SRV350 (surround speakers for SA-VS350H) (front and surround speakers for SA-VS150H) Speaker system 2 way Speaker units Woofer: 60 . 100 mm, cone type Tweeter: 25 mm, balanced dome type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 150 W Sensitivity level 81 dB (1 W, 1 m) Frequency range 120 Hz - 50,000 Hz Dimensions (w/h/d) Approx. 82 . 184 . 98 mm, including front grille Mass Approx. 1.0 kg SA-WVS350 (subwoofer) Speaker system Active subwoofer Speaker units Woofer: 150 mm (. 2), cone type Enclosure type Acoustically Loaded Bass reflex Reproduction frequency range 28 Hz - 200 Hz Continuous RMS power output 150 W (6 ohms 100 Hz, 10% THD) Input LINE IN (input pin jack) General Power requirements 220 - 230 V AC, 50/60 Hz Power consumptions 90 W/less than 0.9 W (standby mode) Dimensions (w/h/d) Approx. 197 . 410 . 505 mm, including front grille Mass Approx. 13 kg Supplied accessories Audio connecting cord (1) Speaker connecting cords (4) Speaker connecting cords (3) Brackets (2) Speaker stands (for surround/surround back speakers) (2) Screws (6) Design and specifications are subject to ...