Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
¦ Using as Normal Stereo Speakers To get the best stereo performance, angle the speakers inward so as to create a triangle, with the listener at the apex. ¦ Using as Front Speakers in a Surround Sound System Position the speakers both side of your TV. The positioning of these speakers is important because they provide a solid anchor for the sound image. They should be positioned facing the listener at about ear level, and equidistant from the TV. Surround L Center Surround R NS-50F Subwoofer Attaching the Stands When placing the speakers, be sure to use the stands to increase stability. Use the 8 specified holes located on the base of the speaker. ¦ Procedure: 1. Put the screw through the inner hole of the stand, and screw it into the outside hole of the speaker. Do not tighten too much at this point. Outer hole Inner hole 2. Put a screw through the outer hole on the stand, and screw it into the other hole on the base of the speaker. 3. Tighten both of the screws firmly. 4. Attach a pad to the bottom of the end portion of the stand. 5. Attach the other stands to the other corners of the base of the speaker in the same way and confirm that all 4 stands have been firmly attached. 4 1 2 English Note: Be careful not to apply force to the side of the speaker, otherwise the speaker may fall causing damage to the speaker or personal injury. E-3 Always turn off your amplifier or receiver before making any connections. ¦ Preparing Your Speaker Cables Carefully remove 10 mm (3/8 ”) of insulation from both ends of your speaker cables and twist the bare wires tightly, as shown. 10 mm (3/8 ”) Good No Good ¦ Hookup SPEAKERS A B LR ++ – – + – Loosen Tighten Amplifier or receiver Notes: • Make sure that the bare wires are not touching each other as this could damage the speaker and amplifier. • Connect one speaker to the left terminals of your amplifier, and another speaker to the right terminals, making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass. ¦ Using a Banana Plug 1 32Banana Plug 1. Remove the speaker terminal cover by gently pulling it toward you. 2. Tighten the terminal knob. 3. Simply insert the banana plug into the terminal. Removing the front cover Removing the front cover Note: When removing the cover, be careful that you don’t touch the drive units, and don’t exert excessive force with any tools. Specifications Type................2-way bass-reflex speaker system magnetic shielding type Drivers...........................3 cm (1 ”) dome tweeter 16 cm (6.5 ”) cone woofer x2 Impedance ......................................................6 . Frequency response .......................35 Hz–35 kHz Nominal Input power................................... 80 W Maximum input power .............................. 240 W Sensitivity...................................90 dB/2.83 V/m Crossover frequency................................... 2 kHz Dimensions (with the stand) (W . ...