Оценок - 5, средний балл: 3
(
)
)
|
Фрагмент инструкции
How this control should be set depends on the position of the subwoofer, the position of the satellite speakers and the gain (amplification factor) of the amplifier used to drive the satellite speakers. Start with the subwoofer volume control at the center of its rotation range. Set all the tone controls on the amplifier to their flat positions and turn off any other controls such as a loudness circuit that will affect the tonal balance of the sound. Listen carefully to a variety of music. Then, if necessary, turn the subwoofer volume control up (clockwise) or down (counterclockwise) slightly. Listen to more music and if necessary adjust the subwoofer volume control again. Experiment with the subwoofer volume control setting until the subwoofer-to-satellite speaker volume is musically well matched. The best subwoofer volume control setting is one that produces a seamless transition from the subwoofer to the satellite speakers. crossover frequency control: The crossover frequency control adjusts what frequency the subwoofer plays below. This control allows you to adjust the subwoofer’s output to take over exactly where the satellite speakers stop. Start with this control set half way and adjust until the sound from the subwoofer and the satellite speakers blends seamlessly. bass EQ control: The bass EQ control can boost or attenuate the subwoofer’s output at around 35Hz with a range of 12dB. This control should be adjusted according to your tastes. Generally, a subwoofer in a corner will need less boost than one placed closer to the center of the room. phase switch: The phase switch can change the subwoofer's phase by 180 degrees in relation to the satellite speakers. This switch should be switched to the position that sounds best in your listening room. power on/off switch: The power switch on the subwoofer has two positions, on and off. power mode switch and protection indicator: The power mode switch has two positions, standby and on. In the standby position the amplifier's signal sensing circuitry will turn it on automatically when an audio signal is applied to the high level or low-level inputs. The protection indicator, located by the on/off switch, will be lit green whenever the unit is on and functioning properly. This indicator will be lit orange when in standby, and red when in protection mode. When there is no signal present at either of the inputs the amplifier will go back to standby mode within about twenty (20) minutes. The subwoofer amplifier monitors its operation. If the subwoofer is operated at a volume level that might damage the amplifier or the woofer, the protection circuit will shut down the amplifiers output and the power indicator will light red. If this happens, turn down the volume and wait for the power indicator to change back to green. If it does not, power down the system and check all connections. hen power the system back on. If all connections are correct it should power back up with the power indicator glowing green. Repeated activation of the protection circuit indicates that the subwoofer is either set up improperly or is being operated in a manner that exceeds it capabilities. speaker level input: A high level input from a receiver or other source. line input: A low level input from a receiver or other source. LFE in/out: The LFE input is designed for use with a surround sound receiver with a dedicated LFE subwoofer output. LFE is a band limited (less than 120 Hz) channel that...
Эта инструкция также подходит к моделям:Акустика - C12ps (437.28 kb)
Акустика - HT12ps (437.28 kb)
Акустика - HT10ps (437.28 kb)
Акустика - C10ps (437.28 kb)