Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
All they require is directional placement. (See tip No. 2.) No. 6: Never let any part of the speaker (except the mounting flange) touch any part of the car. You’ll be amazed what noises a speaker (and your car) can produce when one touches the other. No. 7: Don’t skimp on the quality of the speaker wiring. All Audiovox speakers include wiring rated to properly transmit the normal power load the speaker is designed for. -3 INSTALLATION INSTRUCTIONS CAUTION: Do not mount the speakers in the following locations: -Where the door window glass comes in contact with the speaker. -Where the speaker comes in contact with the window crank handles or gear assemblies when rotated. -Where the speakers come in contact with the trunk springs, shock towers, or trunk lid. -Where the speakers come in contact with gas tanks or fuel lines. -Where the speakers come in contact with the rear window glass, car wall, etc. We strongly recommend that you read these instructions first before you commence speaker installation. If the instructions appear to be too difficult, or if you lack any of the equipment necessary to finish the job, perhaps it would be more prudent to refer the installation to a qualified, car stereo professional. Ease of Installation -The car manufacturer provides at least two, and possibly four, pre-cut openings in all cars. When only two are provided, one is usually in the rear deck and the other is in the front dash. Provisions for four speakers usually include two rear deck openings and two door or dash openings. A car manufacturer picks speaker locations that simplify installation and fit available spaces. They are not always the best places for sound reproduction. Using Factory Openings -The one advantage to using the factory openings is you avoid having cut sheet metal, as the holes are pre- punched. You normally have only to cut away thin plastic or fiber panels that conceal the openings. Openings near the floor should be avoided if at all possible. Be Innovative -If you’re mechanically inclined, remove door panels, dash, side panels, etc., and really get into the basic construction of the car. You’ll be amazed at the vast amount of good-toexcellent speaker locations a car can conceal. If You Don’t Wish to Cut Holes - Consider the hang-on or surface- mount type of speakers. Just pick a reasonably flat panel, drill a few holes, fasten a few screws, and you’re listening to stereo. INSTALLING OVAL SPEAKERS IN REAR DECKS OR FLAT SURFACES Most cars are factory-equipped with speaker openings in the rear deck (package shelf). By examining the underside of this panel, using trunk access, you will probably find at least one (usually two) oval-shaped holes in the steel underliner of the rear deck. The size of these holes vary with the make of car, but the most common openings are for 6”x9”, 5”x7”, and 4”x10” speakers. Occasionally, you’ll find a 5” or 5-1/4” round hole. Selecting the Speaker Location Use the following guidelines to select the speaker loc...
Эта инструкция также подходит к моделям:Акустика - Prestige PS-2571 (105.27 kb)
Акустика - Prestige PS-2696 (105.27 kb)
Акустика - Prestige PS-2697 (105.27 kb)
Акустика - Prestige PS-2461 (105.27 kb)