Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
This will also prevent you from "losing" the wire in the ceiling. Before attaching the wire(s), make sure the speaker wire(s) runs through, not around, the metal mounting bracket. installation preparation Use the supplied template to outline the mounting hole. Cut the mounting hole and remove any debris from the area. Take the necessary steps to keep debris from falling into the back of the speaker. Route the wire(s) from the amplifier to the speaker installation location. Connect the speaker wire(s) to the color-coded terminals. Strip about 1/2" of the insulation from the wire conductors. Twist the wire strands of the conductors into neat bundles. Insert wire(s) into wire holes on speaker plugs and tighten set screws. Plug speaker plugs into crossover terminals on the PC board. final installation The speaker is held in place with four mounting clamps that are part of the assembly. When shipped from the factory the clamps are pivoted so they will fit into the mounting hole. When the mounting hole clamp screws are turned, the clamps pivot outward and are then drawn downward until they press against the back of the mounting surface. Insert the speaker/mounting bezel assembly into the mounting hole. Hold the speaker in place in the mounting hole and evenly tighten the four mounting screws to draw the mounting brackets against the backside of the wall. Gradually tighten the screws, moving from one to another, until the speaker is firmly clamped in place. custom painting • Paint the speaker frame and grill before mounting to the wall; paint grill and frame separately. • Before painting, mask the recessed area of the speaker to completely protect the speaker drivers. • After painting the grill, gently blow through its perforated holes to prevent paint clogging. operation checking the system Listen carefully to each speaker. If you hear buzzing or rattling noises, remove the speaker and check for a speaker wire(s) or other objects touching the speaker assembly. When you are satisfied with the installation press the grills into place. tweeter protector If a speaker sounds "dull", or "lacks "brilliance", you may have activated the tweeter protector. If high power operation causes the tweeter to stop playing, turn down the volume control until normal sound resumes. specifications C50ic C60ic C62ic C80ic (Stereo) Frequency response (Hz) 81-20kHz 57-20kHz 65-20kHz 52-20kHz impedance 8 ohm 8 ohm 8 ohm x 2 8 ohm Sensitivity 1W/1M (dB) 86dB 87dB 87dB 88dB max bezel diameter 8 1/16" 9" 9" 10 11/16" mounting hole 6 9/16" 7 3/4" 7 3/4" 9 7/16" rear clearance 2 5/8" 3 1/4" 3 1/4" 3 5/8" recommended power 20-80watts 20-80watts 20-80watts x 2 20-80watts Woofer 5 1/4" 6 1/2" 6 1/2" 8" Tweeter 3/4" dome 3/4" dome 1" dome X 2 1" dome (Specifications subject to change without notice) warranty information LIMITED FIVE YEAR CONSUMER WARRANTY FOR PRODUCT INSTALLED BY AN AUTHORIZED LICENSED DEALER Directed Electronics, Inc. promises to the original purchaser, to replace this...
Эта инструкция также подходит к моделям:Акустика - C60ic (116.23 kb)
Акустика - C62ic (116.23 kb)
Акустика - C50ic (116.23 kb)
Акустика - C60ic (116.23 kb)