Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
2.AM/FM RADIO BAND SELECTOR: Select between FM STEREO/FM(mono)/AM. 3.VOLUME DIAL:Adjust the volume level up or down. 4.TUNING DIAL:Adjust the radio channel frequency up or down. 5.iPod PLAY/PAUSE BUTTON 6.iPod SKIP / SEARCH FORWARD BUTTON 7.iPod SKIP / SEARCH BACKWARD BUTTON 8.LCD DISPLAY 9.TIME SET BUTTON: Select clock setting mode. 10.HOUR BUTTON: Set hour value of clock. 11.MIN BUTTON: Set minute value of clock. 12.iPod DOCKING COMPARTMENT 13.COMPARTMENT DOOR LOCK 14.SPEAKERS 15.iPod DOCKING CONNECTOR 16.AUX IN----An Audio Cable with a 3.5mm stereo plug for the connection of external audio device. 17.FOLDING PLATFORM ---- A sitting platform for the external audio device. 18.CLOCK BATTERY COMPARTMENT 19.DC JACK----To connect to external DC power supply. 20.STEREO HEADPHONES JACK 21.MAIN BATTERY COMPARTMENT ---- To install main batteries for the Radio / Speaker operation. 22. DETACHABLE STAND ---- A plastic stand for the desk top sitting. 23.ROPE HOLDER ----For attaching hanger rope. 9 RADIO OPERATIONS 1.Slide theFUNCTION selector to Radio mode. 2.Slide the AM/FM BAND selector to select desired radio band. 3.Rotate theTUNING dial until the desired broadcasting is received. 4.Rotate theVOLUME dial to adjust the sound level. REMINDER : Make sure theFUNCTION selector at OFF position when the radio is not in use. TIPS FOR THE BEST RECEPTION : To obtain the best AM/FM reception, slightly rotate the unit until the clearest signal is received or place it near outdoor. NOTE : (1) When weak FM radio signal is received, the unit will automatically switch to FM mono mode even if the BAND selector is set at the FM stereo position. (2) The iPod may cause interference to the AM reception if it is docked and turned ON. You should turn off the iPod manually or remove it from the unit for better reception. (3) Due to the use of high efficiency AC adaptor in this product, it may cause some interference to AM radio. We strongly recommend you use battery when listening to AM. IPOD DOCKING® 1.Release theiPod DOCKING COMPARTMENT DOOR LOCK. 2.Open the compartment door. 3.Insert your iPod with its connector faced downward and directly over the dock connector inside the compartment. CAUTION : Please be careful when seating the iPod into the docking to avoid damaging the 30-pin connector on iPod or the docking system. 4.Close and lock the compartment door. 5.Slide theFUNCTION selector to iPod position. The iPod will start playing automatically. 6.Rotate theVOLUME dial to adjust volume to your desired level. NOTE : The volume level cannot be adjusted by the volume of your iPod after being docked. 7.The iPod is charging even in playback state. NOTE : The iPod recharge function operates in iPod and AUX modes when the unit is powered by external AC adaptor. When the unit is operated by the main battery alone, the iPod recharge function disabled. 8.To remove the iPod from the unit, press and hold the PLAY/PAUSE button for three seconds to switch off the device and then gently take the device out. You may control the playback of your iPod by : - Press thePLAY/PAUSE button to pause or resume the iPod playback. - Press theSKIP/SEARCH FORWARD or BACKWARD button to skip to next or previous song. - Press and hold the SKIP/SEARCH FORWARD or BACKWARD button for fast-forwarding or fast-rewinding during playback. NOTE : To avoid waterdamage inside the docking compartment or water damage to your iPod, please make sure your hands are dry and you only open the docking compartment whenyou are not near water. It is important to tightly lock the compartment door properlybefore using near water. 1 2 3 4 56789 10 11 12 13 14 14 15 16 18 17 19 20 2122 23 (Text) (Text) (Text) (Text) 10 AUXILIARY INPUT The auxiliary input cable and plug are built in the unit and allows users to connect their MP3 player or other digital audio player to the docking system. 1.Release theiPod DOCKING COMPARTMENT DOOR LOCK. 2.Open the compartment door. 3.Take out theAUX IN stereo plug and unwire the AUX cable from the bobbin. 4.Connect theAUX IN stereo plug to the line-out jack or headphone jack of an external audio device. 5.Switch on the external audio device. 6.Slide theFUNCTION selector to AUX position. 7.Rotate theVOLUME dial to adjust volume level. 8.Fold down the FOLDING PLATFORM and sit the external audio device on the platform. 9.Close and lock the compartment door. NOTE: 1. If you connect the line-out jack of your external device then you only need to adjust the volume control of this unit. If you connected the headphone jack of your external device then you may need to adjust both the volume control of your external device and the volume control of this unit to find the most desirable volume setting. 2. Slide theFUNCTION selector to OFF position turning off the unit when you finish listening. Don't forget to switch off the power of your external device as well. 3. To avoid waterdamage inside the compartment or damage to your digital audio player, please make sure your...