Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
14.) Volume + Button. 15.) Volume – Button. 16.) Skip Forward / Tuning (Up) Button. 17.) Skip reverse / Tuning (Down) Button. 18.) Band/iPod Play Button. 19.) iPod® Shuffle USB Connector. 20.) iPod® 30-Pin Connector. 21.) Time/Display Button. 22.) Memory Button. 23.) Preset + Button. 24.) Preset – Button. 9 iP550_041907.p65 9 19/4/2007, 17:56 LCD Display 1 2 3 4 5 6 7 8 9 10 11 121314 1.) Volume Level (00-64), Sleep Time, Radio Channel Display. 2.) VOLUME Indicator. 3.) MEMORY Indicator. 4.) FM Indicator. 5.) SLEEP Timer Indicator. 6.) RADIO Select Indicator. 7.) iPod Select Indicator. 8.) Battery Low Indicator. 9.) AUX Select Indicator. 10.) FM STEREO Indicator. 11.) MUTE Indicator. 12.) Clock, Radio Frequencies Display. 13.) Clock PM Indicator. 14.) AM Indicator. 10 iP550_041907.p65 10 19/4/2007, 17:56 Remote Control 6 7 5 8 9 4 10 11 3 12 2 1 13 1.) iPod Play/Band Button. 14 2.) Skip reverse / Tuning – Button. 3.) Volume + Button. 4.) Mute Button. 5.) Time / Display Button. 6.) Infrared Transmitter. 7.) Power Button. 8.) Memory Button. 9.) Function Button. 10.) Preset + Button. 11.) Preset – Button. 12.) Skip Forward / Tuning + Button. 13.) Volume – Button. 14.) Lithium Battery Compartment (Back Cabinet). R 11 iP550_041907.p65 11 19/4/2007, 17:56 Remote Control The remote control supplied with this system allows you to operate all of the features and functions found on the main unit control panel. The remote control receiver is located behind the left speaker grill. The effective operating distance of the remote control is approximately 15 feet. Please note that bright sunlight can interfere with the proper operation of the remote control, so the operating range may be reduced when the unit is used outdoors on a sunny day. IMPORTANT! Please note that the iPod® Shuffle has no interface to accept commands from a remote control. The remote control of this system will not operate an iPod® Shuffle. You must use the controls on the Shuffle itself to operate an iPod® Shuffle. Remote Control Battery The remote control requires one 3V lithium button battery, Type CR2025 or equivalent, included. To preserve the life of the battery a small clear plastic spacer tab is installed between the battery and the battery terminal. This tab must be removed before the remote control can be used. To remove the tab simply pull it out of the battery compartment, as shown, and discard it. 12 iP550_041907.p65 12 19/4/2007, 17:56 When the operation of the remote becomes intermittent or fails completely you should replace the battery as soon as possible. The battery number is CR2025 or equivalent. To replace the battery, put the remote control face down, slide the battery holder out of the remote control as shown in the illustration. Remove the original battery from the holder and install a new CR2025 battery with the “+” side facing up. Then slide the battery holder back into the remote control. CAUTION DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE. 13 iP550_041907.p65 13 19/4/2007, 17:56 OPERATING INSTRUCTIONS • Make sure that you have either installed the 8 “C” batteries or have connected the unit to your household AC outlet. • Make sure that you have removed the clear plastic battery spacer tab from the remote control. Setting The Clock NOTE: The clock can only be set while the system is in the power ‘Off’ mode. If the power is ‘On’ press the Power button on the main cabinet or remote control to shut the power ‘Off’, the proceed to set the clock as follows: 1.) Press the Time/Display button once. The display lighting turns on and the Hour digits begin to flash. 2.) While the Hour digits are flashing press the ( ) or ( ) buttons to move the display forward or back to the desired hour. Be sure to observe the AM or PM indicator to make sure you have set the hour correctly. 3.) Press the Time/Display button again. The Hour digits stop flashing and the Minute digits begin to flash. 4.) While the Minute digits are flashing press the ( ) or ( ) buttons to move the display forward or back to the desired minute. 14 iP550_041907.p65 14 19/4/2007, 17:56 5.) When the correct time appears on the display press the Time/Display button once more to enter the time and start the clock running. The Minute digits stop flashing and only the colon (:) continues to flash once per second to confirm that the clock is running. NOTES: After pressing the Time/Display button you must press the ( ) or ( ) buttons within 10 seconds while the display is flashing or the time cannot be adjusted. If the display backlighting goes off and the display stops flashing before you can set the time, repeat the above clock setting procedure and make sure that you adjust the time within 10 seconds after pressing the Time/Display button. The correct time will appear on the display when the system is in the power ‘Off’ mode, the iPod mode, or the AUX mode. When the system is in the RADIO mode the display will show the A...
Эта инструкция также подходит к моделям:Акустика - iP550BK (2.22 mb)