Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
"READY TO CLEAN" will be displayed and an audible alarm will sound when the grill is at the proper cleaning temperature. Press the • GREEN pushbutton to display "OFF." The "OFF" position on the controller allows the operator to raise and lower the platen, (for clamshell grills), to alternate positions for cleaning of the platen edges. 2. Empty and replace the grease troughs. Grease troughs should be emptied and replaced consistent with store security policy. 3. Put on the protective gloves and wipe down the exposed surface of the release sheet with a damp grill cloth. 4. Remove the release sheet locking clips and bars. Clean the release sheets following the instructions provided by your local cleaning chemical supplier. 5. Scrape only the lower grill surface with the grill scraper, and squeegee any residue into the grease troughs with the grill squeegee. Caution: Do not scrape or otherwise scratch the upper platens. The use of metal scrapers, abrasive pads, or wire brushes will permanently damage the surface of the upper platens. 6. Open one packet of McD Hi-Temp Grill Cleaner, (HCS), and empty the contents into a suitable container. (One packet cleans a 3ft. grill). 7. Firmly attach the McD NO-SCRATCH™ Pad to the pad holder. 8. Dip the NO-SCRATCH™ Pad into the grill cleaner. 9. Spread a light coating of grill cleaner over the entire platen surface, BACK, FRONT AND SIDE EDGES of all upper platens. DO NOT SCRUB WHILE APPLYING THE PRODUCT. 10. After applying the grill cleaner, lightly scrub the platen surfaces, BACK, FRONT AND SIDE EDGES with the NO-SCRATCH™ Pad until all the soil has been liquefied by the grill cleaner. For stubborn soils, apply additional grill cleaner and lightly scrub. DO NOT RINSE THE PLATENS AT THIS TIME. 11. Starting at the back of the lower grill, spread a light coating of grill cleaner over the entire surface. DO NOT SCRUB WHILE APPLYING THE PRODUCT. 12. After applying the grill cleaner, lightly scrub the grill surface with the NO-SCRATCH™ Pad until all the soil has been liquefied. 13. Rinse the upper platens with a dripping wet grill cloth. RINSE PLATEN EDGE THOROUGHLY, THEN WIPE DOWN BACK EDGE OF PLATEN. 14. Carefully pour small quantities of lukewarm water onto the grill while brushing the surface, backsplash, and bullnose with a LONGLIFE™ pot brush or equivalent high-temperature brush. Continue until the water no longer boils away and the grill remains wet. Squeegee dry. P/N 4521779 (11/29/07) ©McDonald’s Corporation • Planned Maintenance Manual • Revised January 2007 Page 1 of 2 Garland 3-Platen Clamshell Grills, Models MWE3W, MWG3W Daily 11A Caution: Ice, cold water, or large quantities of water must never be applied to the grill plate or upper platen. Severe damage to the grill will occur! 15. Clean the release sheets as follows: 16. Place the sheets on the lower grill. Scrub both sides of the sheets with the same McD NO-SCRATCH™ Pad used on the grill. Note: It is generally not necessary to ap...
Эта инструкция также подходит к моделям:Грили - CLAMSHELL MWE3W (182.86 kb)