Войти:
Оценок - 1, средний балл: 4 ( )

Инструкция по эксплуатации Brinkmann, модель 2600 Series

Производитель: Brinkmann
Размер: 1.17 mb
Название файла: 92b12ed4-30ba-84c4-7588-40c5c65ebbe3.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


DO NOT use a flashlight to check for bubbles. PRE-START CHECK LIST: Property damage, bodily harm, severe burns, and death could result from failure to follow these safety steps. These steps should be performed after the grill has been assembled, stored, moved, cleaned, or repaired. DO NOT operate this grill until you have read and understand ALL of the warnings and instructions in this manual. WARNING • Insure that the grill is properly assembled. • Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. Hose should be at least 3 inches from hot surfaces. • Leak check all gas connections and hose. See section on "Leak Testing". • Ensure that all electrical supply cords are properly grounded and are kept away from water and hot surfaces. • Position your grill on level ground in a well ventilated location, a safe distance from combustible materials and buildings. • Properly place the empty grease tray under the grease drain hole in the bottom of the grill to catch grease during use. WARNING Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual. LIGHTING INSTRUCTIONS: Follow the instructions exactly. 1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all burner control knobs and the cylinder valve are turned to the OFF position. 3. Turn on the fuel supply by rotating the cylinder valve knob counterclockwise to full open. 4. DO NOT stand with head, body, or arms over the grill when lighting. WARNING LIGHTING THE MAIN BURNERS: 1. Open lid before lighting burner. 2. Make sure all control knobs are in the OFF position. 3. Select the burner to be lit. Push and turn the control knob of that burner to the HIGH position. 4. Press the electronic igniter and hold for 3-5 seconds until burner ignites. 5. If burner does NOT ignite immediately, turn the burner control knob to OFF, wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 5 until burner ignites. 6. If burner does not ignite using the push button igniter wait 5 minutes, see "Match Lighting the Main Burners" section. 7. Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the HIGH position. MATCH LIGHTING THE MAIN BURNERS: 1. Open lid before lighting. Lighting Hole Matchlighter 2. Turn the burner control knobs to OFF. 3. Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in the right hand side of the grill to approximately 1/2" (2 to 3 cm) from the burner. 4. Turn on the FAR RIGHT burner control knob to the HIGH position. The burner should light within 5 seconds. 5. If the burner does not light, turn the control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 5 until the burner ignites. 6. Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the HIGH position. 7. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See “Trouble Shooting” section of this manual. OFF HIGH HIGH LOWLOW LOW LOW HIGH HIGH OFF OFFOFF 1. Read and follow all warnings and instructions in owner’s manual before lighting. 2. Open lid before lighting burner. 3. Make sure all control knobs are in the OFF position. 4. Select the burner to be lit. Push and turn the control knob of that burner to HIGH. 5. Press the electronic igniter and hold for 3-5 seconds to light burner. 6. If burner does NOT ignite immediately, turn control knob to OFF, wait 5 minutes to allow gas to dissipate and repeat lighting procedure. 7. Repeat Steps 4-6 for lighting each burner. Always use electronic igniter for lighting each burner. 8. Refer to owner’s manual for match lighting procedure. 9. For assistance, call 1-800-527-0717. 10. To turn off, turn control knobs clockwise until it locks in OFF position. GRILL LIGHTING INSTRUCTIONS: SIDE B LIGHT INSTR 1. Fol 1-3 LIG INS 2. Pus SID con HIG 3. Fol 5-1 LIG INS FOR OUTDOOR USE ONLY LIGHTING THE SIDE BURNER: 1. Open lid to the side burner before lighting. 2. Turn on the side burner by pressing in and rotating the control knob to the HIGH position. 3. Press and hold the igniter button on the main control panel for 3-5 seconds until the burner ignites. 4. If burner does not ignite immediately, turn the burner control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 4 until burner ignites. 5. If burner does not ignite using the push button igniter wait 5 minutes, see "Match Lighting the Side Burner" section. MATCH LIGHTING THE SIDE BURNER: 1. Open lid before lighting. 2. Turn the burner control knob...


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории