Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
2. Insert Telescoping Legs into Receptors with spring clips inside legs. Important: Orient legs so small tube welded to leg faces inward. This will ensure proper fit of the Wire Brace. Legs extend by pushing in on both spring clips protruding from the legs and pulling the legs outward. Then lock leg in place by aligning spring clips with holes in legs. Always be sure spring clip is protruding through holes in legs to ensure stability. Small tubes must face inward Spring Clip Telescoping Leg Receptor 3. Assemble Wire Brace to all 3 legs by inserting ends into the small tube welded to each leg. If wire brace does not fit, check Step 2 above to be sure small tube is facing inward. Wire Brace Small Tube 4. Attach Handles to Firebox with 2 bolts, washers & nuts. Place washer between nut and firebox. Be careful not to overtighten bolts as this could crack the porcelain finish on the Firebox. 5. Attach Handle to Lid with 2 bolts, washers & nuts. Again, be careful not to overtighten bolts as this could crack the porcelain finish on the Lid. 6. Assemble Damper to Lid with 1 bolt & nut. 7. Assemble Screen Assembly by inserting Hinge Pin into hinges of mating sections. 8. Place Charcoal Grate into Firebox; place Screen Assembly along top edge of Firebox & place Lid on top of Screen Assembly. You are now ready for use as either a Fireplace or Charcoal Grill. Hinge Pin Set Up and Use AS A FIREPLACE WARNING Never leave unit unattended when hot or in use. Keep out of reach ofchildren. For outdoor use only. Never use in enclosed area. Use in unventilated areas will endanger your life. 1. Place unit on a level, noncombustible surface with legs in lowered position. Keep well away from house, garage, balconies or eave overhangs. 2. Be sure charcoal grate is placed in firebox. Add newspaper, kindling & wood on top of charcoal grate. 3. Place screen assembly along top edge of firebox. 4. Ignite newspaper & kindling with match or butane lighter. Use charcoal lighter fluid if necessary. 5. Once fire is well lit, place lid on top of screen assembly. Set Up and Use AS A CHARCOAL GRILL WARNING Never leave unit unattended when hot or in use. Keep out of reach ofchildren. For outdoor use only. Never use in enclosed area. Use in unventilated areas will endanger your life. 1. Place unit on a level, noncombustible surface with legs in raised position. Keep well away from house, garage, balconies or eave overhangs. 2. Be sure charcoal grate is in place in firebox. Place charcoal over charcoal grate and ignite charcoal as instructed on charcoal packaging. Use charcoal lighter fluid as needed. 3. Once charcoal is well lit, place cooking grate on top of firebox and begin cooking! After Use WARNING To avoid burns – use heavy gloves to remove screen assembly and grates. 1. Completely extinguish fire before leaving. Extinguish fire by removing screen assembly and placing lid over firebox with damper closed. 2. Do not use water to douse the fire as this may crack the porcelain finish of the firebox. 3. Dispose of cold ashes properly. 4. Be careful – fire may be out but firebox can still be hot. Handle carefully. 5. Store in covered enclosure or disassemble and place in carrycase. See Storage section below. Storage in Carrycase 1. Clean all components prior to storing in carrycase. This will prevent unwanted odors and extend the life of your fireplace/grill. 2. To disassemble, remove lid, screen assembly and cooking grate. 3. Disassemble the wire brace and telescoping legs from the firebox. 4. Insert cleaned cooking grate into bottom pocket of carrycase and close straps. 5. With legs in short position, insert them through the elastic straps inside the carrycase. Each leg should be held down by two straps. 6. Next place wire brace on top of legs. 7. Fold screen assembly by removing hinge pin and folding the screen sections over on each other. Then place folded screen assembly in firebox on top of charcoal grate. 8. Place firebox into carrycase. For best fit, orient firebox so handles extend out to match oblong shape of carrycase. 9. Place lid on top of firebox and zip carrycase shut. Maintenance & Care of Fireplace • Extreme heat from fire may cause paint to burn off from Screen Assembly. To help restore look & protect steel, use a wire brush to clean, then repaint with high temperature black paint. • Always store unit in covered enclosure, preferably in carrycase. • Check that bolts on handles, leg receptors & damper are tight with no loose fitting pieces. Parts List 23141385677711109 10 I.D. PART NO. DESCRIPTION NO. 1 5065-2351 Lid 2 5065-1051 Firebox 3 5065-2451 Screen Assembly 4 5065-1251 Screen Hinge Pin 5 5065-3251 Cooking Grate 6 5065-3351 Charcoal/Wood Grate 7 5065-4151 Handles (Set of 3) 8 5065-1161 Leg Receptors (Set of 3) 9 5065-4251 Telescoping Legs (3) 10 5065-1351 Wire Brace 11 5065-4351 Damper 12 5065-4051 Fastener Hardware 13 5065-1001 Carrycase 5-Year Limited Warranty The Coleman Company, Inc. (“Coleman”) warrants that for a perio...