Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
The Burner can also be lit manually, see Manual Lighting of the Grill on page 28. Manually Lighting the Grill ! WARNING To reduce the risk of serious bodily injury or death from fire or explosion: • Open Hood before lighting the grill to prevent an explosion from gas build-up. 1. Open the Hood. 2. IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 4 - P.27) 3. Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5- P.27) 4. Locate match-lighting hole at the right end of the Grill Bowl. Push in and turn the far right Main Burner Control Knob, near the match-lighting hole, counterclockwise to the “High” position. 5. Insert a lit match through the match-lighting hole (Fig. 7) 6. From the “Off” position, light all other Burners, making sure each Burner is lit before lighting the next. Your grill has a Crossover Ignition System that allows the Burners to light successively off one another. Confirm each Burner is lit before lighting another Burner. Insert lit match through matchlighting hole under the right side table. Fig. 7 If any or all Burners fail to light after three or four attempts following Steps 3-4, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting procedures. NOTE: If the Burner still fails to light, refer to the Troubleshooting Section. 7. After ignition, turn the Control Knobs to “High” for 3-5 minutes and close the Hood to preheat the grill. Preheat the grill before every cooking session. If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill. 29 29 Lighting the Side Burner (Model 6122 Only) ! WARNING To reduce the risk of serious bodily injury or death from fire or explosion: • Open Side Burner Lid before lighting the grill to prevent an explosion from gas build-up. 1. Open the Side Burner Lid. (Fig. 8) NOTE: Side Burner Lid is to remain open while the Side Burner is on or hot. 2. IMPORTANT: Make sure the Side Burner Control Knob is turned “Off” first. (Fig. 4 - P.27) 3. Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5 - P.27) 4. Push Side Burner Control Knob in and turn counterclockwise to the High position. (Fig. 4 - P.27) 5. Push the Piezo Igniter Button several times so that it clicks each time. Look to make sure the Burner is lit. If no spark, see Troubleshooting Section on page 37. 6. If the Burner fails to light, repeat Step 4-5. If the Burner fails to light after three or four attempts following Steps 4-5, turn the Side Burner Control Knob to the “Off” position, and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting procedures. NOTE: If the Burners still fail to light, refer to Troubleshooting Section. The Burner can be lit manually, see Manually Lighting the Side Burner. Side Burner Control Knob Manually Lighting the Side Burner Fig. 8 Open Lid 1. Open the Side Burner Lid. 2. IMPORTANT: Make sure Side Burner Control Knob is turned “Off” first. 3. Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5 - P.27) 4. Push Side Burner Control Knob in and turn counterclockwise to the High position. 5. Hold lit Match near Burner. 6. If the Burner fails to light, repeat Steps 4-5. If the burner fails to light after three or four attempts following Steps 3-5, turn the Side Burner Control Knob to the “Off” position and close the LP Gas Cylinder valve to dissipate an accumulated gas. Wait five minutes; then repeat the lighting procedure. NOTE: If the Burners still fail to light, refer to Troubleshooting Section. Cooking On the Gas Grill ! WARNING To reduce the risk of serious bodily injury or death from fire, explosion or burn hazard: • Never use charcoal or lighter fluid in your gas grill. Keep this outdoor cooking appliance clear and free from combustible materials, gasoline, and other flammable vapors and liquids. • Keep any electrical supply cord and regulator hose away from any heated surfaces. • Make sure there are no gas leaks or obstructions to the flow of combustion and ventilation air before each use. • Keep the ventilation openings of the LP Gas Cylinder enclosure free and clear from debris. • Always open the Hood before lighting the LP gas grill. • Do not attempt to extinguish a grease fire with water or other liquids. Have a BC fire extinguisher accessible. Never douse or spray the grill or cooking surfaces with water when hot. Burns from grease or water splatters could occur. • If your gas grill catches on fire: - If the fire is in the grill portion and you can safely reach the Control Knobs on the Control Panel, then turn them to the “Off” position. - If the fire is in one of the hoses, and you can safely reach the LP Gas Cylinder valve, then shut the valve off. - If the fire ...
Эта инструкция также подходит к моделям:Грили - VANTAGE 6112S8X641 (2.02 mb)