Check entire box and inside all packing material for parts. Before beginning assembly, read the instructions and identify parts in this document. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly. During assembly, if using a ladder use extreme caution. Two people are recommended for this operation. If tech

Label is shown on page 1 If technical assistance is required, contact Huffy Sports. Adult supervision is recommended when adjusting Most injuries are caused by misuse and/or not following Use caution when using this system. For more information on assembly, placement, maintenance, visit The American Basketball The NBA and individual NBA copyrighted designs, and/or Properties, Inc. and the respective written consent of NBA Toll-Free 1-800-558-For Canada: 1-800-284-For Europe: 00 800 555 (Sweden:

Climate, corrosion, excessive use, or misuse could result in system failure. If technical assistance is required, contact Huffy Sports. Minimum operational height is 6'6" (1.98 m) to the bottom of backboard. This equipment is intended for home recreational use only and NOT excessive competitive play. Adult supervision is recommended when adjusting height. Serious injury could occur if teeth/face come in contact with backboard, net, or rim. Read and understand the warning label enclosed with hard

(2.4m) • Adjustable Wrench • Wrenches: (Two) 1/2” (One) 3/4” • Phillips Screwdriver WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the unit. In the U.S.: 1-800-558-5234 and Canada Only: 1-800-284-8339 In Australia: 1-800-632-792 206118 5/97 See instruction manual for proper installation and maintenance. Use caution when performing dunk type activities on this unit.

10 14 20 7 1421 12 10 THREE PERSON MINIMUM REQUIRED FOR THIS PROCEDURE. NOT FOLLOWING RECOMMENDATION MAY RESULT IN SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE. WARNING REAR VIEWIMPORTANT! Do not over tighten. 9 12/02 P/N 211446D Rotate jack handle clockwise to raise H-frame (13) to approximately 7’ (2.1 m) from ground. Secure crank jack (20) to jack brackets (17 &18) as shown. NOTE: Some adjustment will be necessary to align the lower crank jack bushing to jack brackets (17 & 18). 15. THREE PER

* IMPORTANT! Holes in top and bottom pole sections MUST align to correctly position elevator system. Continue to check alignment while assembling pole sections. *Row of 3 holes on top pole section must be parallel with adjustment knob. Once assembled, pole sections can NOT be separated! POLES MUST OVERLAP 3-1/2” (9 CM) MINIMUM. NOTE: Discard this carriage bolt immediately after completing this step. DO NOT discard flange nut and washer. 6 printed on recycled paper 4 P/N 211387 5/99 6. 6. Attach

PLEASE WRITE YOUR MODEL NUMBER IN THE SPACE PROVIDED ABOVE. Toll-Free Customer Service Number for U.S: 1-800-558-5234 Internet Address: © COPYRIGHT 2002 by HUFFY SPORTS 1 12/02 P/N 211670 McCall's REBOUNDER PARTS LIST (See Hardware Identifier) REBOUND ARM Item Qty. Part No. Description 1 1 200416 Base (Black) 2 4 200417 Casters 3 1 200419 Left Support Brace 4 1 201875 Right Support Brace 5 1 200423 Outer Pole Assembly 6 1 201876 Inner Pole, Fixed Upright 7 1 201877 T-Screw OUTER POLE GRADUATED S

Read and understand operator's manual before using this unit. Failure to follow operating instructions could result in injury or damage to property. REQUIRED TOOLS AND MATERIALS: • Two People • Wood Board (Scrap) • Tape Measure • Step Ladder 8 ft. (2.4 m) • Tape • Garden Hose or Sand 360 lb. (163 kg) • Hammer • Wrenches: (Two) 1/2”, (One) 9/16” or Two Small Adjustable Wrenches (9/16” Deep Socket w/Extension Recommended) • Support Table Toll-Free Customer Service Number for U.S: 1-800-558-5234, F

20 4 203104 Bolt, Hex Flange, 5/16-18 x 2 Long 21 2 200837 Spacer, Plastic 22 2 201562 U-bolt, Round, 3/8-16 x 2-3/4 Long 23 1 Net 24 1 201190 Cap 25 1 203124 Tie Down Stake 26 2 201651 Spacer, Wheel Axle 27 1 201568 T-Strap 28 1 201189 Tank Cap 29 4 200516 Bolt Covers, Black Vinyl * You may have extra parts with this model. * Units with 42” steel frame acrylic backboard do not require the use of included board struts (.75” x 22”) HARDWARE IDENTIFIER (BOLTS & NUTS) Item #12 (1)Item #8 (5) Item #

1 Remove contents from tank Remove contents from tank 2. Correctly identify each pole section and mark indicated distance from ends with tape (not supplied) as shown. TOP 4 TAPE (Not Supplied) MIDDLE 5 5” (13 cm) BOTTOM 6 5” (13 cm) 3. IMPORTANT! Center the alignment slot of middle pole section (5) in the lower hole of top pole section (4) as shown. While maintaining alignment, bounce middle section of pole (5) into top section of pole (4) using wood scrap as shown until they no longer move towa