Оценок - 4, средний балл: 3.8
(
)
)
|
Фото и характеристики AEG L 60260 TL |
Фрагмент инструкции
Make regularly a maintenance wash. To do this: • Empty the laundry from the drum. • Set the hottest cotton wash programme • Use a correct quantity of powder detergent with biological properties. After each wash, keep the door open for a while to prevent mould and to let unpleasant smells go out. To clean the dispenser: 1. Remove the detergent dispenser and disconnect the two parts. 2. Clean all the parts with water. 3. Assemble the two parts of the detergent dispenser. 4. Put back the detergent dispenser. WARNING! • Disconnect the mains plug from the mains socket. • Do not remove the filter while the appliance operates. Do not clean the drain filter if the water in the appliance is hot. The water must be cold before you clean the drain filter. DRAIN FILTER Regularly examine the drain filter and make sure that it is clean. To clean the drain filter: 18 1. Open the drain filter door. 2. Put a container below the recess of the drain filter to collect the water that flows out. Turn the filter until it is vertical. 3. Turn the filter fully and remove it. 4. Remove fluff and objects. 5. Clean the filter with water. 6. Put it back and screw it in. 7. Make sure that you tighten correctly the filter to prevent leakages. 8. Close the drain filter door. THE INLET HOSE FILTER AND THE VALVE FILTER WARNING! • Disconnect the mains plug from the mains socket. To clean the water inlet filters: 1. Close the water tap. 2. Remove the water inlet hose from the water tap. 3. Clean the filter in the inlet hose with a stiff brush. 90°90° ENGLISH 19 4. Remove the inlet hose behind the appliance. 5. Clean the filter in the valve with a stiff brush or a towel. 6. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. 7. Open the water tap. EMERGENCY DRAIN Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (3) of 'To clean the drain filter'. If necessary, clean the filter. Put the drainage duct back and close the drain filter flap. FROST PRECAUTIONS If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. 1. Close the water tap and disconnect the inlet hose. 2. Put the end of the inlet hose in a container and let the water flow out of the hose. 3. Do the Drain programme and let it operate until the end of the cycle. 4. Turn the programme knob to Stop to disconnect the appliance from the power supply. 5. Disconnect the appliance. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. 20 TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water. • - The appliance does not drain the water. • - The appliance door is open or not closed correctly. • - The anti-flood device is on. WARNING! Deactivate the appliance before you do the checks. Problem Possible cause Possible solution The appliance does not fill with The water tap is closed. Open the water tap. water. The water inlet hose is Make sure that the water inlet damaged. hose has no damages. The filters in the water in-Clean the filters. Refer to 'Care let hose is blocked . and cleaning'. The water tap is blocked or is furred with lime- Clean the water tap. scale. The connection of the Make sure that the connection is water inlet hose is not correct. correct. The water pressure is too low. Contact your local water authority. The appliance The water drain hose is Make sure that the water drain does not drain the damaged. hose has no damages. water. The filter of the drain pump is blocked. Clean the filter of the drain pump. Refer to 'Care and clean- ing'. The connection of the water drain hose is not correct. Make sure that the connection is correct. A washing programme without the drain phase is set. Set the drain programme. The function Rinse & Hold is on. Set the drain programme. The appliance door is open or not closed correct- ly. Close the door correctly. ENGLISH 21 Problem Possible cause Possible solution The anti-flood de- vice is on. • Disconnect the appliance. • Close the water tap. • Contact the service centre. The spin phase The spin phase is off. Set the spin programme. does not operate. The filter of the drain pump is blocked. Clean the filter of the drain pump. Refer to 'Care and clean- ing'. Balance problems with the laundry load. Adjust manually the items in the tub and start the spin phase again. The programme does not start. The mains plug is not connected in the mains Put in the mains plug. socket. Blow out fuse in the household fuse box. Replace the fuse. You did not press button 4 . Press button ...
Эта инструкция также подходит к моделям:Стиральные машины - L 60060 TL (1.56 mb)