#JM10748 printed in ChinA ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

• Secure the unit carefully to prevent movement when it is transported. • A unit that receives a strong shock during transport and unloading may malfunction. STORAGE • Clean and rinse tank and spraying assembly after each use to prevent crystallizing, which would later cause clogging and chemical damage to the unit. • Do not store sprayer under pressure, or with spray solution in tank. • When storing the sprayer, choose a space indoors free from moisture and out of the reach of children. 4. Afte

Use good judgment! IMPORTANT: Whenever the blade guard cannot be used, the riving knife must be installed. Button Figure 68. Button for removing pawls. Riving Knife ▲WARNING To ensure that the riving knife works safely, it MUST be aligned with and correctly adjusted to the blade. Refer to Page 68 to check or adjust the riving knife alignment. The riving knife works in the same manner as the spreader on the blade guard assembly. It is a metal plate that prevents the newly cut workpiece fro

6/10+) MS -85- Cabinet -86- M G0605X1-6X1, G0696X-97X (Mfg. 6/10+) Cabinet Parts List REF PART # DESCRIPTION REF PART # DESCRIPTION 5 P0605X137 STRAIN RELIEF 7 PN02M HEX NUT M10-1.5 8 PW04M FLAT WASHER 10MM 9 PLW06M LOCK WASHER 10MM 16 PFB15M FLANGE BOLT M8-1.25 X 12 27 PLW04M LOCK WASHER 8MM 38 PK14M KEY 5 X 5 X 18 39 PB14M HEX BOLT M10-1.5 X 35 42 PCAP31M CAP SCREW M8-1.25 X 25 43 P0605X1043 WOODRUFF KEY 22 X 5 47 P0605X1047 HANDWHEEL 48 P0605X014 HANDWHEEL LOCK KNOB 49 PSS17

Many parts in spray guns are made of alu- minum. Readsolvent label carefully before using solvent. NOTICE DO NOT soak the spray gun body in solvent. Prolonged exposure to solvent will rapidly deteriorate the spray gun washers and seals. Ignoring this notice will void your warranty. Model G5352 Spray Gun -13 Lubrication Figure 14. Lubrication points. A B C D E F Lubricate the following areas with a non- silicon spray gun lubricant after cleaning. A. Atomizing Cap Threads B. Air Valve Packing C. T

#PC8208 PRINTED IN TAIWAN SECTION 1: SAFETY Indicates a potentially hazardous situation which, if not avoided, MAYresult in minor or moderate injury. It may also be used to alert against unsafe practices. Indicates a potentially hazardous situation which, if not avoided, COULDresult in death or serious injury. This symbol is used to alert the user to useful infor- mation about proper operation of the equipment. For Your Own Safety Read Instruction Manual Before Operating This EquipmentThe purpos

Build-up of material inside atomizing cap. 1. Clear holes. 2. Clean. 3. Clean. Heavy deposit of material in center. 1. The material flow exceeds the atomizing cap capacity. 2. Inlet air pressure is too low. 3. Material is too thick. 1. Lower fluid flow. 2. Increase inlet air pressure. 3. Thin material. Narrow center pat- tern. 1. Volume control turned in too far. 2. Inlet air pressure too high. 3. Fluid pressure is too low. 4. Material is too thin. 1. Increase volume. 2. Reduce inlet air pressur