Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 3 CK5038_032404.p65 3 24/3/2004, 11:27 PREPARATION FOR USE PREPARATION FOR USE UNPACKING AND SET UP •Remove the radio from the carton and remove all packing material from the radio. We suggest that you save the packing material, if possible, in the unlikely event that your radio ever needs to be returned for service. The original carton and packing material is the only safe way to pack your radio to protect it from damage in transit. •Remove any descriptive labels or stickers on the front or top of the cabinet. Do not remove any labels or stickers from the back or bottom of the cabinet. •Note the serial number on the bottom of your radio and write this number in the space provided on Page 2 of this manual. •Place your radio on a level surface such as a table, desk or shelf, convenient to an AC outlet, out of direct sunlight, and away from sources of excess heat, dirt, dust, moisture, humidity, or vibration. •Unwind the AC power cord and extend it to its full length. The FM antenna is built in to this cord. It must be fully extended to provide the best FM reception. SURE-ALARM BATTERY BACK UP SYSTEM The Sure-Alarm battery back up system in this radio will maintain the time and alarm settings in the event of a temporary power interruption. When the power is restored the time and alarm settings will be correct. If the power is off at your wake up time, the Sure-Alarm system will use the battery power to turn on the radio or buzzer alarm as usual, as long as the back up battery is installed and has sufficient power remaining. The Sure-Alarm battery back up system requires one 9-volt battery, not included. We recommend that you install an alkaline battery for longest life and best performance. 4 CK5038_032404.p65 4 24/3/2004, 11:27 TO INSTALL THE BATTERY • Open the battery compartment cover on the bottom of the radio by sliding the cover in the direction of the arrow. • Connect the 9-volt battery to the battery SLIDE TO OPEN terminal. It can only be connected one way. • Push the battery into the battery compartment and replace the cover. POWER FAILURE INDICATOR If no battery is installed in the radio, or if the battery in the compartment is weak or dead, the time and alarm settings will be lost if the power is interrupted. When the power is restored the clock display will begin flashing. This is your indication that the time display is incorrect and needs to be reset. Important: After you reset the time, be sure to reset your alarm settings as well. 5 CK5038_032404.p65 5 24/3/2004, 11:27 POWER SOURCE This radio is designed to operate on normal 120V 60Hz AC power only. Do not attempt to operate the radio on any other power source. You could cause damage to the radio that is not covered by your warranty. This radio should be connected to an AC outlet that is always ‘live’. Do not connect it to an outlet that is controlled by a wall switch. When the power to the radio is interrupted, the Sure Alarm battery back up system takes over to maintain the time and alarm settings. To maximize the life of the back up battery, keep the radio connected to a ‘live’AC outlet at all times. This radio uses a polarized AC plug which has one blade wider than the other. This plug will only fit into a polarized AC outlet. This is a safety feature. If the plug will not fit, you may have an older non-polarized AC outlet. Do not defeat the safety feature by trying to file the wider blade, or replacing the plug. Contact an electrician to replace your outdated outlet. AC Outlet AC Plug 6 CK5038_032404.p65 6 24/3/2004, 11:27 7 LOCATION OF CONTROLS AND INDICATORS 22 23 24 19 20 21 1 2 3 4 5 6 7 8 9 10 11 NAP SLEEP ON / OFF TOP PANEL FRONT PANEL LEFT SIDE PANEL RIGHT SIDE PANEL 12 14 15 16 17 13 18 88 93 98 104 108 530 650 800 1000 1300 1710 FM MHz AM KHz CK5038_032404.p65 7 24/3/2004, 11:27 1.) SNOOZE/SLEEP OFF) Button. 2.) SLEEP Button. 3.) RADIO ON/OFF Button. 4.) TIME Setting Button. 5.) ALM (Alarm) 1 Setting/Reset Button. 6.) AC Power Cord. 7.) Speaker. 8.) NAP Button. 9.) ALM (Alarm) 2 Setting/Reset Button. 10.) Set UP Button. 11.) Set DOWN Button. 12.) Back Up Battery Compartment (Bottom Cabinet). 13.) ALM (Alarm) 1 ‘On’Indicator. 14.) AM indicator. 15.) Time Display. 16.) NAP Indicator. 17.) Dial Pointer. 18.) ALM (Alarm) 2 ‘On’Indicator. 19.) DIMMER (LOW/HIGH) switch. 20.) ALARM 2 (RADIO/BUZZ/OFF) Selector Switch. 21.) ALARM 1 (RADIO/BUZZ/OFF) Selector Switch. 22.) TUNING Control. 23.) BAND (FM/AM) Switch. 24.) VOLUME Control. 8 CK5038_032404.p65 8 24/3/2004, 11:27 OPERATING INSTRUCTIONS O...