To install the R-8 collet: 1. UNPLUG THE MILL/DRILL! 2. Remove the drawbar cap. 3. Carefully clean the surface of the collet and spindle taper. Ensure that it is free of debris, oil and grease of any kind. 4. Insert the cutting tool into the collet. 5. Insert the collet up into the spindle taper. 6. Slide the collet the rest of the way in until it makes contact with the threads at the end of the drawbar. 7. Using your fingers, thread the drawbar into the collet until the collet draws up into the

Everyday eyeglasses only have impact resistant lenses, they are NOT safety glasses. 12. SECURE WORK. Use clamps or a vise to hold work when practical. It’s safer than using your hand and frees both hands to operate tool. 13. DON’T OVERREACH. Keep proper footing and balance at all times. 14. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest performance. Follow instructions for lubricating and changing accessories. 15. DISCONNECT TOOLS before servicing and changing accessori

CLOSURE................................................................................................................20 GENERAL MACHINE DATA ..............................................................................21 PART BREAKDOWN ........................................................................................22 PART LIST ........................................................................................................23 WARRANTY AND RETURNS.................................

29 x 18 x 22 in. .......................................................220V, Single-Phase, 60 Hz .........................................................30A @110V, 15A @220V Front Mounted Forward Reverse Switch with Emergency Stop ......................................................................................... 220V .........................................................................................6.5 ft. .....................................................................

.. .. .. .. .. .. .. .... .... .... .... .... .... .... .... .... .... .... .... .... .... .... .... .... .... .... .... .... .... .. .. .... .... .... Column Parts List REF PART # DESCRIPTION REF PART # DESCRIPTION P0643001 KNURLED KNOB PSS01M SET SCREW M6-1 X 10 P0643003 DEPTH CONTROL PSB02M CAP SCREW M6-1 X 20 P0643005 WING SCREW M6-1 X 35 PSB11M CAP SCREW M8-1 X 16 PW01M FLAT WASHER 8MM PSB14M CAP SCREW M8-1.25 X 20 P0643009 DEPTH CONTROL MOUNT P0643010 LIFTING EYE BOLT P0643011 COLUMN PSB33

#JB10659 printed in ChinA ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

Model g5789/g5790 inventory. Model g5789/g5790 13-piece 3.4" impact wrench Kit -3 -4- Model G5789/G5790 13-Piece 3.4" Impact Wrench Kit OPERATIONS ACCIDENTAL START HAZARD ! Disconnect before service or tool changes. AIR PRESSURE HAZARD ! Never exceed 120 PSI . LUNG /EAR IN JURY HAZARD ! Wear protective equipment when using this tool. Read the manual before operation. Become familiar with this tool, its safety instructions, and its operation before beginning any work. Serious personal injury may

Do not use the angle vise for milling. It is made strictly for holding materials to be drilled. This vise will not adequately clamp an object safely for a milling operation. There is not enough clamping pressure available and objects may be pulled out or upset in the vise jaws causing cutting tools to break and/or parts to be thrown. Any attempt to perform a milling operation using this vise may result in personal injury. DO NOT make adjustments while the Mill/Drill is running. Ensure that the s